Owner's manual

FLYFOT-MG260-MODULE
Page: 53 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
To ascertain which code must be entered (or not), the following query command can be used:
AT+ CP IN ?
The possible responses are :
+CPIN: READY
+CPIN: SIM PIN
+CPIN: SIM PUK
+CPIN: SIM PIN2
+CPIN: SIM PUK2
+CPIN: PH-SIM PIN
+CPIN: PH-NET PIN
+CME ERROR: <err>
ME is not pending for any password
CHV1 is required
PUK1 is required
CHV2 is required
PUK2 is required
SIM lock (phone-to-SIM) is required
Network personnalisation is required
SIM failure (13) absent (10) etc…
Please note that in this case the mobile equipment does not end its response with the OK string.
The response +CME ERROR : 13 (SIM failure) is returned after 10 unsuccessful PUK attempts. The SIM
card is then out of order and must be replaced by a new one.
Example: 3 failed PIN validations + 1 successful PUK validation
AT+ CP IN?
+CPIN: SIM PIN
AT+CPIN=1235
+CME ERROR: 16
AT+CPIN=1236
+CME ERROR: 16
AT+CPIN=1237
+CME ERROR: 16
AT+ CP IN?
+CPIN: SIM PUK
AT+CPIN=99999999,5678
OK
AT+ CP IN?
+CPIN: READY
Read the PIN status
The product requires SIM PIN
First attempt to enter a SIM PIN
Wrong PIN
Second attempt
Wrong PIN
Third attempt
Wrong PIN
Read PIN state
The product requires PUK
The PUK is entered, the new PIN shall be 5678
PUK validation is OK. New Pin is 5678
Read PIN state
The product is ready
Defined values :
<pin> Personal Identification Number.