Owner's manual

FLYFOT-MG260-MODULE
Page: 31 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged
without prior written agreement.
+VTD Syntax:
Command syntax: AT+VTD=<n>
Command Possible responses
AT+ V TD = 6
Note: To define600 ms tone duration
OK
Note: Command valid
AT+ V TD = 0
Note: To set the default value
OK
AT+ V TD ?
Note: interrogate current tone duration
+VTD: <n>
OK
AT+ V TD = ? +VTD: (0-255)
OK
Defined values :
<n> : tone duration
<n>*100 is the duration in ms.
If n < 4, tone duration is 300 ms; if n > 255, the value is used modulo 256.
Default value is 300 ms, that is <n> = 3.
+VTS Description:
The product enables the user application to send DTMF tones over the GSM network. This
command enables tones to be transmitted, only when there is an active call.
+VTS Syntax:
Command syntax: AT+VTS=<Tone>
Command Possible responses
AT+VTS=A OK
Note: Command valid
AT+VTS=11 +CME ERROR: 4
Note: If the <Tone> is wrong
AT+VTS=4 +CME ERROR: 3
Note: If there is no communication
Defined values:
<Tone>:
The value is in {0-9, *, #, A, B, C, D}
Example:
To send tone sequence 13#, the application sends:
AT+VTS=1; +VTS=3; +VTS=#
OK
5.7 Redial last telephone number ATDL
Description:
This command is used by the application to redial the last number used in the ATD command. The last
number dialed is displayed followed by “;” for voice calls only