Owner's manual

FLYFOT-MG260-MODULE
Page: 180 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
<value>
0: I/O port number <index> is reset.
1: I/O port number <index> is set.
18.9 Write GPIO value +WIOW
Description
Set the requested GPO or GPIO pin value.
Note :
z by default (after a reset), the I/O ports configuration is set by the +WIOM command.
z This command is allowed only on a GPIO not allocated by the Open-AT embedded application
or for bus operations.
Syntax
Command syntax: AT+WIOW=<index >,<value>
Defined values
<index>
Eight I/O ports are available. The <index> value is between 0 and 7.
<value>
0: I/O port number <index> is reset.
1: I/O port number <index> is set.
18.10 Input/Output Management +WIOM
Description
This specific command allows to set the default GPIOs configuration (input or output) after reset, and
each GPIO default value (if set as an output) after reset.
Note :
z This command is allowed only on a GPIO not allocated by the Open-AT embedded
application or for bus operations.
Syntax
Command Syntax AT+WIOM=[<GpioDir>],[<GpioVal>]
Command Possible responses
AT+WIOM? +WIOM: 255,0