User Manual

MAX6791–MAX6796
High-Voltage, Micropower, Single/Dual Linear
Regulators with Supervisory Functions
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS
(V
IN
= 14V, C
IN
= 1µF, C
OUT
= 10µF, T
A
= T
J
= -40°C to +125°C, unless otherwise noted. Typical values are at T
A
= T
J
= +25°C.)
(Note 1)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
(All pins referenced to GND, unless otherwise noted.)
IN to GND ...............................................................-0.3V to +80V
ENABLE, ENABLE1, ENABLE2, PFI,
GATEP to GND ...........................................-0.3V to (IN + 0.3V)
GATEP to IN ...........................................................-12V to +0.3V
OUT, OUT1, OUT2, PFO, RESET (open-drain versions),
CSRT, CSWT .......................................................-0.3V to +12V
HOLD, RESET (push-pull versions), WDI, WDS0, WDS1,
WD-DIS, SET, SET1......................-0.3V to (OUT/OUT1 + 0.3V)
OUT, OUT1, OUT2 Short Circuit
to GND....................................................................Continuous
Maximum Current (all pins except IN and OUT_)...............50mA
Continuous Power Dissipation (T
A
= +70°C)
20-Pin TQFN (derate 33.3mW/°C above +70°C) .....2666.7mW
Operating Temperature Range (T
A
)..................-40°C to +125°C
Junction Temperature (T
J
) .................................................150°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering, 10s) .................................+300°C
PARAMETER
SYMBOL
CONDITIONS
MIN TYP MAX
UNITS
Supply Voltage Range V
IN
572V
Regulators on (I
LOAD
= 0mA), V
IN
= 8V 68 85
V
IN
= 8V, I
LOAD
= 300mA
(MAX6795/MAX6796)
130
220
V
IN
= 14V, I
LOAD
= 100mA
(MAX6795/MAX6796)
100
160
V
IN
= 8V, I
LOAD1
= I
LOAD2
= 150mA
(MAX6791–MAX6794)
130
220
Regulators on,
OUT/OUT1 =
OUT2 = 5V
V
IN
= 14V, I
LOAD1
=
I
LOAD2
= 50mA
(MAX6791–MAX6794)
100
160
Regulators on (I
LOAD
= 0mA), V
IN
= 42V 74 95
Supply Current I
IN
Regulators on (I
LOAD
= 20mA, total)
OUT1/OUT2/OUT = 5V, V
IN
= 42V
100
170
µA
Shutdown Supply Current I
SHDN
Regulators off, V
IN
= 14V 27 45 µA