Manual

MAX5961
0 to 16V, Quad, Hot-Swap Controller
with 10-Bit Current and Voltage Monitor
32 ______________________________________________________________________________________
Using the Voltage and
Current Peak-Detection Registers
The voltage and current minimum- and maximum-value
records in register locations 0x10 through 0x2F can be
reset by writing a 1 to the appropriate location in regis-
ter peak_log_rst (see Table 36). The minimum-value
registers are reset to 0x3FF, and the maximum-value
registers are reset to 0x000.
As long as a bit in register peak_log_rst is 1, the corre-
sponding peak-detection registers are disabled and
are “cleared” to their power-up reset values. The volt-
age and current minimum- and maximum-detection
register contents for each signal can be “held” by set-
ting bits in register peak_log_hold (see Table 37).
Writing a 1 to a location in register peak_log_hold locks
the register contents for the corresponding signal and
stops the min/max detection and logging; writing a 0
enables the detection and logging. Note that the peak-
detection registers cannot be cleared while they are
held by register peak_log_hold.
The combination of these two control registers allows
the user to monitor voltage and current peak-to-peak
values during a particular time period.
Table 35. ADC Maximum Voltage Conversion Register Format (Low-Order Bits)
Description: Maximum voltage conversion result, low-order bits [1:0]
Register Titles: max_ch1_mon_l max_ch2_mon_l max_ch3_mon_l max_ch4_mon_l
Register Addresses: 0x17 0x1F 0x27 0x2F
R/W R/W R/W R/W R/W R/W R/W R/W
RESET
VALUE
vmax_1 vmax_0 0x00
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
Table 36. Peak-Detection Reset-Control Register Format
Description: Reset control bits for peak-detection registers
Register Title: peak_log_rst
Register Address: 0x73
R/W R/W R/W R/W R/W R/W R/W R/W
RESET
VALUE
ch4_v_rst ch4_i_rst ch3_v_rst ch3_i_rst ch2_v_rst ch2_i_rst ch1_v_rst ch1_i_rst 0x00
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
Table 37. Peak-Detection Hold-Control Register Format
Description: Hold control bits for peak-detection registers; per signal
Register Title: peak_log_hold
Register Address: 0x74
R/W R/W R/W R/W R/W R/W R/W R/W
RESET
VALUE
ch4_v_hld ch4_i_hld ch3_v_hld ch3_i_hld ch2_v_hld ch2_i_hld ch1_v_hld ch1_i_hld 0x00
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0