Owner's manual

MAX5092/MAX5093
4V to 72V Input LDOs with Boost Preregulator
4 _______________________________________________________________________________________
ELECTRICAL CHARACTERISTICS (continued)
(V
IN
= V
EN
= 14V, I
OUT
= 1mA, C
IN
= 47µF, C
BSOUT
= 22µF, C
OUT
= 10µF, C
VL
= 1µF, T
A
= T
J
= -40°C to +125°C, unless otherwise
noted. See Figures 4–7 as applicable. Typical specifications are at T
A
= +25°C.) (Note 2)
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
ENABLE, HOLD and RESET
EN High Input Threshold EN
H
2.4 V
EN Low Input Threshold EN
L
0.4 V
EN Input Bias Current I
EN
0.25 2 µA
HOLD Low Input Threshold V
IL
Regulator on, EN transition from high to low 0.4 V
HOLD Release Voltage V
IH
EN = low
V
OUT
-
0.4
V
HOLD Pullup Current I
HOLD
Internally connected to OUT 4 µA
RESET Voltage Threshold V
RESET
% of V
OUT
, V
OUT
falling 87 90 92 %
RESET Threshold Hysteresis V
RHYST
% of V
OUT
2%
RESET Output Low Voltage V
RL
I
SINK
= 1mA 0.4 V
RESET Output High Leakage
Current
I
RH
V
R E SE T
= 5V 1 µA
RESET Output Minimum Timeout
Period
C
CT
not connected 25 µs
EN to RESET Minimum Timeout
Delay
C
CT
not connected 260 µs
Delay Comparator Threshold
(Rising)
V
CTTH
1.205 1.24 1.265 V
Delay Comparator Threshold
Hysteresis
V
CTTH-HYS
100 mV
CT Charge Current I
CT-CHG
1.5 2 2.5 µA
CT Discharge Current I
CT-DIS
5mA
Note 2: Limits at -40°C are guaranteed by design and characterization; not production tested.
Note 3: Guaranteed minimum operating voltage is 3.5V on V
IN
falling only.
Note 4: Guaranteed by design and not production tested.
Note 5: The continuous maximum output current from the LDO is guaranteed according to the maximum power dissipation imposed
by the package thermal constraints.
Note 6: Maximum output adjustable value is conditioned by the maximum adjustable BSOUT Output Voltage Range minus the maxi-
mum dropout across the pass transistor.
Note 7: Dropout voltage is defined as (V
BSOUT
- V
OUT
) when V
OUT
is 2% below the value of V
OUT
for V
BSOUT
= V
OUT
+ 2V.