Instruction Manual

ISD1916
Publication Release Date: September 11, 2007
- 4 - Revision 0
2.1. Address trigger operational mode
• While in NORM mode, flexible message duration is defined by start address and end
address.
•
Utilize four start addresses ( S0 , S1 , S2 & S3 ) and four end addresses ( E0 , E1 , E2 & E3 ) to
specific the message duration.
•
REC : Level-hold or Edge-trigger (toggle on-off) recording from start to end addresses.
•
PLAYE : Edge-trigger playback from start to end addresses and stops at EOM marker, if EOM
is prior to end address. Toggle on-off.
• PLAYL : Level-hold playback from start to end addresses. Also, if constantly Low, device will
loop playback from start to end addresses.
2.2. Direct trigger operational mode
• While
MODE
is active, utilizing, FMC1, FMC2 &
FMC3
, the device reconfigures some pins to
adapt various (1 to 8) fixed equal message configurations for random access and pre-defines
the fixed message duration accordingly.
• The control pins are:
M1 ~ M8 (message activation) and /PR (record or playback selection).
• The record or playback operation is pre-defined by the
/PR pin.
• Each message can be randomly accessed via its message control pin (
M1 ~ M8 ) and the
desired operation is facilitated accordingly.