User Manual

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 374 of 434
#ESAV - E-mail Parameters Save SELINT 0 / 1
AT#ESAV
Execution command stores the e-mail parameters in the NVM of the device.
The e-mail parameters to store are:
- E-mail User Name
- E-mail Password
- E-mail Sender Address
- E-mail SMTP server
Note If some parameters have not been previously specified then a default value
will be taken.
#ESAV - E-mail Parameters Save SELINT 2
AT#ESAV
Execution command stores the e-mail parameters in the NVM of the device.
The e-mail parameters to store are:
- E-mail User Name
- E-mail Password
- E-mail Sender Address
- E-mail SMTP server
AT#ESAV=?
Test command returns the OK result code.
Note If some parameters have not been previously specified then a default value
will be taken.
3.5.7.6.9 E-mail Parameters Reset - #ERST
#ERST - E-mail Parameters Reset SELINT 0 / 1
AT#ERST
Execution command resets the e-mail parameters to the “factory default”
configuration and stores them in the NVM of the device.
The e-mail parameters to reset are:
- E-mail User Name
- E-mail Password
- E-mail Sender Address
- E-mail SMTP server
#ERST - E-mail Parameters Reset SELINT 2
AT#ERST
Execution command resets the e-mail parameters to the “factory default”
configuration and stores them in the NVM of the device.
The e-mail parameters to reset are:
- E-mail User Name
- E-mail Password
- E-mail Sender Address
- E-mail SMTP server
AT#ERST=?
Test command returns the OK result code.