User Manual

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 117 of 434
+CPIN - Enter PIN SELINT 0 / 1
%E #SKTSET +CGMI $GPSP
%L #SKTOP +CGMM $GPSPS
%Q #SKTCT +CGMR $GPSR
\Q #SKTSAV +GMI $GPSD
\R #SKTRST +GMM $GPSSW
\V #ESMTP +GMR $GPSAT
#SELINT #EADDR +CGSN $GPSAV
#CGMI #EUSER +GSN $GPSAI
#CGMM #EPASSW +CHUP $GPSAP
#CGMR #SEMAIL +CRLP $GPSS
#CGSN #EMAILD +CR $GPSNMUN
#CAP #ESAV +CRC $GPSACP
#SRS #ERST +CSNS $GPSWK
#SRP #EMAILMSG +CREG $GPSSAV
#STM #CSURV +COPS $GPSRST
#PCT #CSURVC +CLIP $GPSCON
#SHDN #CSURVU +CPAS $GPSPRG
#WAKE #CSURVUC +CFUN
#QTEMP
All the above commands, but the ones in the grayed cells, can be issued
even if the SIM card is not inserted yet.
All the above commands, but +CSDH and +CNMI, can be issued even if ME
is waiting for phone-To-SIM card password to be given
Reference GSM 07.07
+CPIN - Enter PIN SELINT 2
AT+CPIN=<pin>
[,<newpin>]
Set command sends to the device a password which is necessary before it
can be operated (SIM PIN, SIM PUK, PH-SIM PIN, etc.).
If the PIN required is SIM PUK or SIM PUK2, the <newpin> is required.
This second pin, <newpin> will replace the old pin in the SIM.
The command may be used to change the SIM PIN by sending it with both
parameters <pin> and <newpin> when PIN request is pending; if no PIN
request is pending the command will return an error code and to change the
PIN the command +CPWD must be used instead.
Parameters:
<pin> - string type value
<newpin> - string type value.
To check the status of the PIN request use the command AT+CPIN?
Note: If all parameters are omitted then the behaviour of Set command is
the same as Read command.