Owner's manual

Easy GPRS User Guide

80000ST10028 Rev. 4 - 16/07/08

3.2 Commands overview

This paragraph describes the configuration and the activation of the GSM context and the new AT

commands implemented to facilitate the use of Easy GSM and Easy GPRS in the same device.

For more information about concerning outgoing and incoming connections, you can refer to the

chapter “Enhanced Easy GPRS Extension“: there are no differences at sockets level.

NOTE: For

more detailed AT commands and parameters definitions consult the AT Commands

Reference Guide.

3.2.1 Configuring GSM access

GSM context definition differs from GPRS one and requires a new command: #GSMCONT, that

replaces, just in GSM case, the standard +CGDCONT. The only parameter to set is the number of the

Internet Service Provider. The command syntax is:

AT#GSMCONT=0, “IP“, <CSD num>

Where

• 0 is the context identifier for the GSM context

• CSD num is the Internet Service Provider number