User Manual

GM862-GPS Software User Guide
1vv0300729 Rev. 5 - 05/07/07
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 115 of 120
5.7.4 Message 105 – Development Data On/Off
Use this command to enable development data information if you are having trouble getting
commands accepted. Invalid commands generate debug information that enables you to determine
the source of the command rejection. Common reasons for input command rejection are invalid
checksum or parameter out of specified range.
The command has the following syntax:
$PSRF105,<Debug>< checksum><CR><LF>
Examples:
1. Debug On
$PSRF105,1*3E
2. Debug Off
$PSRF105,0*3F
The following table describes the command fields:
Name Example Unit Description
Message ID $PSRF105 PSRF105 protocol header
Debug 1 0=off, 1=On
Checksum *3E
<CR><LF> End of message termination