Owner's manual

GM862-GPS Hardware User Guide

1vv0300728 Rev. 8 - 20/09/07

- Angle connector fixing example 2 -

NOTE: in the examples the cable is always bent, this is not a constrain. If the installation does not

require it, then the cable can be kept straight, ensuring that the fixing is without sliding.

13.2 Precautions

• The plug should be inserted in the connector only after the installation of the Telit GM862-

GPS modules

in the board. This is to prevent accidental breaking of the antenna connection

during the transport.

• The coaxial cable must be fixed at least in one point, without sliding possibilities.

• The plug insertion/removal must be done axially with the female connector of the GM862,

keeping lateral strains to a minimum.

• The insertion/crimping pull out force must be less than 15N.

• The Hole’s diameter for GM862 shielding reed soldering is: (1,5 +/- 0,05) mm