Manual

Global Configuration Commands
Power Off +CPOF
©Restricted
Page: 82 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 1 August 23, 2007
6.9 Power Off +CPOF
6.9.1 Description
This Wavecom proprietary command stops the GSM software stack and the
hardware layer or the Wireless CPU
®
activity. The AT+CFUN=0 command is
equivalent to +CPOF.
Note:
In autobaud mode, after a +CPOF unsolicited information waking up the Wireless
CPU
®
is sent at 9600 bps until an AT command is sent. When an AT command is
sent, the Wireless CPU
®
will synchronize to the sender speed. (see CAUTION in § 180H8.2
Fixed DTE rate +IPR in Serial Ports Commands section).
6.9.2 Syntax
Action command
AT+CPOF[=<mode>]
OK
Read command
None
Test command
None
6.9.3 Parameters and Defined Values
<mode>: power off mode
1 power off
6.9.4 Parameter Storage
None.