Manual

Battery Commands
Wavecom Autodiag +WDIAG
©Restricted
Page: 102 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 4 August 23, 2007
<indication>: type of event
0 current value (not available in best effort mode)
1 ADC value is under the minimum threshold value (<trig1>)
2 ADC value is above the minimum threshold value (<trig1>)
(only after an unsolicited response with <indication>=1)
3 ADC value is under the maximum threshold value (<trig2>)
4 ADC value is under the maximum threshold value (<trig2>)
(only after an unsolicited response with <indication>=3)
5 The delta between two values among the <trig3freq> last
values is more important than the delta threshold value
(<trig3>)
<value>: ADC value in mV
range: 1-8000
for <indication> = 0: the current ADC value
for <indication> = 2: the minimum ADC value read while
the minimum threshold has been exceeded.
for <indication> = 4: the maximum ADC value read while
the maximum threshold has been exceeded.
for <indication> = 5: the delta ADC value read
23.3.4 Parameter Storage
The parameters are stored in EEPROM using the AT&W.command The default value
can be restored using AT&F.