Manual

I/O Commands
Wavecom Interrupt Pin Configuration +WIPC
©Restricted
Page: 85 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 4 August 23, 2007
22.4.3 Parameters and Defined Values
<InterruptId>: interrupt pin identification
0 interrupt INT0
1 interrupt INT1
<mode>: requested configuration
0 the PIN is configured as GPIO
1 the PIN is configured as Interruption (default)
<EdgeState>: interruption raising mode
0 interruption happens with high to low edge (default)
1 interruption happens with low to high edge
2 interruption happens with both edge (high to low and low to
high edge): de-bounce processing is applied
<ProcessingMode>:
0 de-bounce (default)
1 by pass
2 stretching
<DebounceTiming>: de-bounce duration in units of 7.8 ms
1-7 default value: 1
22.4.4 Parameter Storage
The <mode>, <EdgeState>, <processingMode> and <DebounceTiming> parameters
are stored in EEPROM without using the AT&W command.