Manual

I/O Commands
Wavecom Interrupt Pin Configuration +WIPC
©Restricted
Page: 84 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 4 August 23, 2007
22.4 Wavecom Interrupt Pin Configuration +WIPC
22.4.1 Description
This Wavecom proprietary command configures an interrupt pin as an interruption or
an I/O pin.
On the Wireless CPU
®
, two interruption pins are available : INT0 (multiplexed with
GPIO3) and INT1(multiplexed with GPIO25).
22.4.2 Syntax
Action command
AT+WIPC=<InterruptId>,<Mode>[,<EdgeState>[,[<ProcessingMode>
[,<DebounceTiming>]]]
OK
Read command
AT+WIPC?
+WIPC: <InterruptId>,<Mode>[,<EdgeState>,<ProcessingMode>
[,<DebounceTiming>]]
[+WIPC: <InterruptId>,<Mode>[,<EdgeState>,<ProcessingMode>
[,<DebounceTiming>]][…]]
OK
Test command
AT+WIPC=?
+WIPC: (list of supported <InterruptId>s), (list of supported
<Mode>s), (list of supported <EdgeState>s), (list of supported
<ProcessingMode>s), (list of supported <DebounceTiming>s)
OK