Manual

Audio Commands
Speaker & Microphone Selection +SPEAKER
©Restricted
Page: 7 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 4 August 23, 2007
21.1.3 Parameters and Defined Values
<ActiveConfig>: speaker mode (please refer to the "Notes" section below)
1 config 1 (default value)
2 config 2
3 config 3
4 config 4
5 config 5 (reserved PCM Bus)
6 config 6 (reserved PCM Bus)
7 config 7 (reserved PCM Bus)
8 config 8 (reserved PCM Bus)
9 config 9 (only digital)
21.1.4 Parameter Storage
The <ActiveConfig> parameter is stored in EEPROM using the AT&W command. The
default value can be restored using AT&F.
21.1.5 Examples
Command Responses
AT+SPEAKER=?
+SPEAKER: (1-9)
OK
AT+SPEAKER=1
Note: Activate config1
OK
AT+SPEAKER?
+SPEAKER: 1
OK
Note: Request current settings Note: Config 1 is active