Manual

Data Commands
V42 Bis Data Compression Report +DR
©Restricted
Page: 81 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 2 August 23, 2007
13.9 V42 Bis Data Compression Report +DR
13.9.1 Description
This command enables/disables the +DR intermediate result code that represents the
current DCE-DCE data compression type. This intermediate result code, if enabled, is
issued before the final result code, after the service report control +CR and before the
+ILRR intermediate report.
13.9.2 Syntax
Action command
AT+DR=<status>
OK
Read command
AT+DR?
+DR: <status>
OK
Test command
AT+DR=?
+DR: (list of supported <status>s)
OK
Intermediate response
+DR: <direction>