Manual

Call Control Commands
Cellular Result Codes +CRC
©Restricted
Page: 63 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 2 August 23, 2007
12.15.3 Parameters and Defined Values
<mode>: extended ring information mode
0 disable (default value)
1 enable
<type>: detailed ring information
ASYNC asynchronous transparent
REL ASYNC asynchronous non transparent
VOICE voice
FAX fax
GPRS GPRS network request for PDP context activation
<PDP_type>: type of packet data protocol
"IP" Internet Protocol (IETF STD 5)
"PPP" Point to Point Protocol (IETF STD 51)
<PDP_addr>: PDP address: identifies the MT in the address space applicable
to the PDP
string type
12.15.4 Parameter Storage
The <mode> parameter is stored in EEPROM using the AT&W command. The default
value can be restored using AT&F.
12.15.5 Examples
Command Responses
AT+CRC=?
+CRC: (0,1)
OK
AT+CRC=1
OK
Note: Extended reports enabled Note: Command valid
AT+CRC?
+CRC: 1
OK
+CRING: VOICE
Note: Incoming voice call