Manual

GSM Network Commands
Registration control +WREGC
©Restricted
Page: 22 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 2 August 23, 2007
11.5 Registration control +WREGC
11.5.1 Description
This Wavecom proprietary command is used by the application to disable GSM
registration and deregistration procedures on the network. If the
registration/deregistration procedure is disabled, the Wireless CPU
®
does not perform
the procedure but considers itself as attached/detached on the network. The
command +WREGC therefore has no impact on the response to AT+CREG?.
11.5.2 Syntax
Action command
AT+WREGC=<mode>
OK
Read command
AT+WREGC?
+WREGC: <mode>
OK
Test command
AT+WREGC=?
+WREGC: (list of supported <mode>s)
OK
11.5.3 Parameters and Defined Values
<mode>: registration control mode
0 all registrations enabled (default value)
1 power up registration disabled
2 power down deregistration disabled
3 power up registration and power down deregistration
disabled
11.5.4 Parameter Storage
The <mode> parameter is stored in EEPROM without using the AT&W command.
The default value can be restored using AT&F.