Manual

Serial Port Commands
Wavecom Ring Indicator Mode +WRIM
©Restricted
Page: 153 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 1 August 23, 2007
bit 15 +WLOC
bit 16 for Open AT
®
applications
If this bit is set, RI pulse will be sent when the unsolicited
response initiated by an Open AT
®
application is sent.
bit 17 +CGREG
bit 18 +CGEV
bit 19 +CSSU
bit 20 +CUSD
bit 21 +WBTUM, +WBTSM
bit 22 +CLAV
<pulse_width>: RI pulse width
used only in pulse RI mode (<mode>=1).
If <pulse_width> parameter is omitted, the last entered value
will be used.
0 duration of pulse is 5 μs (default value)
1-33 duration of pulse in units of 30 μs.
Caution:
Pulse duration may be increased by
up to 3 ms, due to
overhead interrupt processes.
8.10.4 Parameter Storage
The parameters are stored in EEPROM without using AT&W command. The default
value can be restored using AT&F.