Manual

Serial Port Commands
DTE-DCE Local Flow Control +IFC
©Restricted
Page: 141 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 1 August 23, 2007
8.4 DTE-DCE Local Flow Control +IFC
8.4.1 Description
This command is used to control the operation of local flow control between the DTE
and DCE.
8.4.2 Syntax
Action command
AT+IFC=<DCE_by_DTE>,<DTE_by_DCE>
OK
Read command
AT+IFC?
+IFC: <DCE_by_DTE>,<DTE_by_DCE>
OK
Test command
AT+IFC=?
+IFC: (list of supported <DCE_by_DTE>s),(list of supported
<DTE_by_DCE>s)
OK
8.4.3 Parameters and Defined Values
<DCE_by_DTE>: local flow control parameter
0 none
2 RTS (default value)
<DTE_by_DCE>: local flow control parameter
0 none
2 CTS (default value)