Owner's manual

DS3131

115 of 174

Bit # 7 6 5 4 3 2 1 0

Name reserved reserved reserved reserved TDQF TDQFE TPQF TPQFE

Default 0 0 0 0 0 0 0 0

Bit # 15 14 13 12 11 10 9 8

Name reserved reserved reserved reserved reserved TDQT2 TDQT1 TDQT0

Default 0 0 0 0 0 0 0 0

Note: Bits that are underlined are read-only; all other bits are read-write.

Bit 0/Transmit Pending-Queue FIFO Enable (TPQFE). See Section 9.3.3 for details.

Bit 1/Transmit Pending-Queue FIFO Flush (TPQLF). See Section 9.3.3

for details.

Bit 3/Transmit Done-Queue FIFO Enable (TDQFE). This bit must be set to 1 to enable the DMA to burst write

descriptors to the done queue. If this bit is set to 0, descriptors are written one at a time.

0 = done-queue burst write disabled

1 = done-queue burst write enabled

Bit 4/Transmit Done-Queue FIFO Flush (TDQF). When this bit is set to 1, the internal done-queue FIFO is

flushed by sending all data into the done queue. This bit must be set to 0 for proper operation.

0 = FIFO in normal operation

1 = FIFO is flushed

Bits 8 to 10/Transmit Done-Queue Status Bit Threshold Setting (TDQT0 to TDQT2). These bits determine

when the DMA sets the transmit DMA done-queue write (TDQW) status bit in the status register for DMA

(SDMA) register.

000 = set the TDQW status bit after each descriptor write to the done queue

001 = set the TDQW status bit after 2 or more descriptors are written to the done queue

010 = set the TDQW status bit after 4 or more descriptors are written to the done queue

011 = set the TDQW status bit after 8 or more descriptors are written to the done queue

100 = set the TDQW status bit after 16 or more descriptors are written to the done queue

101 = set the TDQW status bit after 32 or more descriptors are written to the done queue

110 = set the TDQW status bit after 64 or more descriptors are written to the done queue

111 = set the TDQW status bit after 128 or more descriptors are written to the done queue