User Manual

DS2153Q
022697 16/48
ALARM CRITERIA Table 4–1
ALARM SET CRITERIA CLEAR CRITERIA
CCITT
SPEC.
RSA1
(receive signaling
all ones)
over 16 consecutive frames (one full
MF) timeslot 16 contains less than 3
zeros
over 16 consecutive frames (one full
MF) timeslot 16 contains 3 or more
zeros
G.732
4.2
RSA0
(receive signaling
all zeros)
over 16 consecutive frames (one full
MF) timeslot 16 contains all zeros
over 16 consecutive frames (one full
MF) timeslot 16 contains at least a
single one
G.732
5.2
RDMA
(receive distant
multiframe alarm)
bit 6 in timeslot 16 of frame 0 set to
one for two consecutive MF
bit 6 in timeslot 16 of frame 0 set to
zero for a two consecutive MF
O.162
2.1.5
RUA1
(receive unframed
all ones)
less than 3 zeros in two frames (512
bits)
more than 2 zeros in two frames (512
bits)
O.162
1.6.1.2
RRA
(receive remote
alarm)
bit 3 of non–align frame set to one for
3 consecutive occasions
bit 3 of non–align frame set to zero for
3 consecutive occasions
O.162
2.1.4
RCL
(receive carrier
loss)
255 consecutive zeros received in 255–bit times, at least 32 ones are
received
G.775
SR2: STATUS REGISTER 2 (Address=07 Hex)
(MSB) (LSB)
RMF RAF TMF SEC TAF LOTC RCMF TSLIP
SYMBOL POSITION NAME AND DESCRIPTION
RMF SR2.7 Receive CAS Multiframe. Set every 2 ms (regardless if CAS signaling is
enabled or not) on receive multiframe boundaries. Used to alert the host
that signaling data is available.
RAF SR2.6 Receive Align Frame. Set every 250 µs at the beginning of align frames.
Used to alert the host that Si and Sa bits are available in the RAF and RNAF
registers.
TMF SR2.5 Transmit Multiframe. Set every 2 ms (regardless if CRC4 is enabled) on
transmit multiframe boundaries. Used to alert the host that signaling data
needs to be updated.
SEC SR2.4 One Second Timer. Set on increments of one second based on RCLK. If
CCR2.7=1, then this bit will be set every 62.5 ms instead of once a second.
TAF SR2.3 Transmit Align Frame. Set every 250 µs at the beginning of align frames.
Used to alert the host that the TAF and TNAF registers need to be updated.
LOTC SR2.2 Loss of Transmit Clock. Set when the TCLK pin has not transitioned for
one channel time (or 3.9 µs). Will force pin 16 high if enabled via TCR2.0.
Based on RCLK.
RCMF SR2.1 Receive CRC4 Multiframe. Set on CRC4 multiframe boundaries; will con-
tinue to be set every 2 ms on an arbitrary boundary if CRC4 is disabled.
TSLIP SR2.0 Transmit Elastic Store Slip. Set when the elastic store has either re-
peated or deleted a frame of data.