Owner's manual

DS1874
SFP+ Controller with Digital LDD Interface
______________________________________________________________________________________ 61
Table 02h, Register 8Bh: CNFGC
FACTORY DEFAULT 00h
READ ACCESS PW2 or (PW1 and RWTBL246) or (PW1 and RTBL246)
WRITE ACCESS PW2 or (PW1 and RWTBL246)
MEMORY TYPE Nonvolatile (SEE)
8Bh RESERVED RESERVED TXDM34 TXDFG TXDFLT TXDIO RSSI_FC RSSI_FF
BIT 7 BIT 0
BITS 7:6 RESERVED
BIT 5
TXDM34: Enables TXD to reset alarms and warnings associated to MON3 and MON4 during a TXD
event.
0 = TXD event has no effect on the MON3 and MON4 alarms, warnings, and quick trips.
1 = MON3 and MON4 alarms, warnings, and quick trips are reset during a TXD event.
BIT 4
TXDFG: See Figure 12.
0 = FETG, an internal signal, has no effect on TXDOUT.
1 = FETG is enabled and ORed with other possible signals to create TXDOUT.
BIT 3
TXDFLT: See Figure 12.
0 = TXF pin has no effect on TXDOUT.
1 = TXF pin is enabled and ORed with other possible signals to create TXDOUT.
BIT 2
TXDIO: See Figure 12.
0 = (Default) TXD input signal is enabled and ORed with other possible signals to create TXDOUT.
1 = TXD input signal has no effect on TXDOUT.
BITS 1:0
RSSI_FC and RSSI_FF: RSSI Force Coarse and RSSI Force Fine. Control bits for RSSI mode of
operation on the MON3 conversion.
00b = Normal RSSI mode of operation (default).
01b = The fine settings of scale and offset are used for MON3 conversions.
10b = The coarse settings of scale and offset are used for MON3 conversions.
11b = Normal RSSI mode of operation.
FACTORY DEFAULT 00h
READ ACCESS PW2 or (PW1 and RWTBL246) or (PW1 and RTBL246)
WRITE ACCESS PW2 or (PW1 and RWTBL246)
MEMORY TYPE Nonvolatile (SEE)
8Ch 2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
BIT 7 BIT 0
This value becomes the I
2
C slave address for the main memory when the ASEL (Table 02h, Register 89h) bit is
set. If A0h is programmed to this register, the auxiliary memory is disabled.
Table 02h, Register 8Ch: DEVICE ADDRESS