Owner's manual

3
Standard ICs BA4510F / BA4510FV
•
Electrical characteristics (unless otherwise noted, Ta = 25°C, VCC = ±2.5V)
Parameter Symbol Min. Typ. Max. Unit
Input offset voltage V
IO —1 6mVRS = 50Ω
Input offset current I
IO — 2 200 nA
Input bias current I
B — 80 500 nA
High-amplitude voltage gain A
V 60 90 — dB
Common-mode input voltage V
ICM – 1.3 — V
Common-mode rejection ratio CMRR 60 80 — dB
Power supply voltage rejection ratio PSRR 60 80 — dB R
S = 50Ω
Quiescent current I
Q 2.5 5.0 7.5 mA
Output voltage
High V
OH 2.0 2.4 — V RL = 2kΩ
Low V
OL — – 2.4 – 2.0 V RL = 2kΩ
Slew rate S.R. 5 V /
µs—
1.5
—
Conditions
R
L⭌2kΩ, VCC = 15V
R
L = ∞ALL AMPS
∗
1
∗
1 Because the first stage is configured with a PNP transistor, input bias current is from the IC.
•
Electrical characteristic curve
POWER DISSIPATION: Pd (mW)
AMBIENT TEMPERATURE: Ta (°C)
1200
1000
800
600
400
200
0
0 25 50 75 100 125 150
BA4510F
BA4510FV
Fig. 1 Power dissipation vs. ambient
temperature
•
Operation notes
(1) Unused circuit connections
If there are any circuits which are not being used, we
recommend making connections as shown in Figure 2,
with the non-inverted input pin connected to the poten-
tial within the in-phase input voltage range (V
ICM).
(2) If used with a voltage follower, be careful of oscilla-
tion which may cause problems with the in-line input
voltage range or the capacitance load.
(3) If using at power supply voltage + 5.0 or higher, be
sure the gain is reduced sufficiently to prevent oscilla-
tion.
VCC
VEE
To potential
in V
ICM
+
–
Fig. 2 Unused circuit connections