Manual

6
4890AS–GPS–09/05
ATR0621 [Preliminary]
EM_A18 B3 OUT
EM_A19 C5 OUT
EM_DA0 B6 I/O PD
EM_DA1 B10 I/O PD
EM_DA2 C7 I/O PD
EM_DA3 C10 I/O PD
EM_DA4 D10 I/O PD
EM_DA5 E7 I/O PD
EM_DA6 E9 I/O PD
EM_DA7 B7 I/O PD
EM_DA8 B8 I/O PD
EM_DA9 A9 I/O PD
EM_DA10 C8 I/O PD
EM_DA11 B9 I/O PD
EM_DA12 D8 I/O PD
EM_DA13 C9 I/O PD
EM_DA14 D9 I/O PD
EM_DA15 E8 I/O PD
GND A1 IN
GND A10 IN
GND K1 IN
GND K10 IN
LDOBAT_IN K8 IN
LDO_EN H7 IN
LDO_IN K7 IN
LDO_OUT H6 OUT
NRESET C4 I/O Open Drain PU
NSHDN G7 OUT
NSLEEP J6 OUT
NTRST K2 IN PD
P0 K9 I/O PD NANTSHORT
P1 G3 I/O Configurable (PD) GPSMODE0 AGCOUT1
P2 G4 I/O Configurable (PD) BOOT_MODE “0” CLK32K
P3 H5 I/O OH NCS1 NCS1 “0”
P4 A7 I/O OH NCS0 NCS0 “0”
P5 B1 I/O OH NWE/NWR0 NWE/NWR0 “0”
Table 3-1. ATR0621 Pinout (Continued)
Pin Name LFBGA100 Pin Type
Pull Resistor
(Reset Value)
(1)
Firmware Label PIO Bank A PIO Bank B
Notes: 1. PD = internal pull-down resistor, PU = internal pull-up resistor, OH = switched to Output High at reset
2. VDDIO is the supply voltage for the following GPIO pins: P1, P2, P8, P12, P14, P16, P17, P18, P19, P20, P21, P23, P24,
P25, P26, P27 and P29
3. VDD_USB is the supply voltage for the following USB pins: USB_DM and USB_DP. For operation of the USB interface, sup-
ply of 3.0V to 3.6V is required.