Manual

12
4890AS–GPS–09/05
ATR0621 [Preliminary]
The following settings apply if GPSMODE configuration is not enabled, that is, GPSMODE = 0
(ROM-Defaults):
3.3.4 USB Power Mode
For correct response to the USB host queries, the device has to know its power mode. This is
configured via GPSMODE7. If set to bus powered, an upper current limit of 100 mA is reported
to the USB host; that is, the device classifies itself as a “low-power bus-powered function” with
no more than one USB power unit load.
Table 3-9. Supported Messages at Setting High
NMEA Port
Standard GGA, RMC, GSA, GSV, GLL, VTG, ZDA, GRS, GST
Proprietary PUBX00, PUBX03, PUBX04
UBX Port
NAV
SOL, SVINFO, POSECEF, POSLLH, STATUS, DOP, VELECEF,
VELNED, TIMEGPS, TIMEUTC, CLOCK
MON SCHD, IO, IPC
Table 3-10. Supported Messages at Setting Debug (Additional Undocumented Message
May be Part of Output Data)
NMEA Port
Standard GGA, RMC, GSA, GSV, GLL, VTG, ZDA, GRS, GST
Proprietary PUBX00, PUBX03, PUBX04
UBX Port
NAV
SOL, SVINFO, POSECEF, POSLLH, STATUS, DOP, VELECEF,
VELNED, TIMEGPS, TIMEUTC, CLOCK
MON SCHD, IO, IPC
RXM RAW (RAW message support requires an additional license)
Table 3-11. Serial I/O Default Setting if GPSMODE Configuration is Deselected
(GPSMODE0 = 0)
USART1/USB
NMEA
USART2
UBX
Baud Rate (kBaud) 57.6, Auto enabled 57.6, Auto enabled
Input Protocol UBX, NMEA, RTCM UBX, NMEA, RTCM
Output Protocol NMEA UBX
Messages GGA, RMC, GSA, GSV NAV: SOL, SVINFO
Information Messages
(UBX INF or NMEA TXT)
User, Notice, Warning, Error User, Notice, Warning, Error
Table 3-12. USB Power Modes
GPSMODE7 (Reset = PU) Description
0 USB device is bus-powered (max. current limit 100 mA)
1 USB device is self-powered (Default)