Owner's manual

5440A–IMAGE–10/05

[Preliminary] ATMOS -2M60/2M30

3. Camera Description

Figure 3-1. Camera Synoptic

The camera is based on a single tap CMOS sensor which delivers a 12-bit digital video signal at

its output. An FPGA has been implemented for image processing (FPN column correction, con-

version LUT, contrast expansion). The camera is powered by a single DC power supply from

12V to 24V. The functional interface (data and control) is provided with the Camera Link inter-

face. The camera uses the base configuration of the Camera Link standard.

Note: DVAL permanently tied to 1 (high) level.

Data is delivered on two channels. The data format configuration might be in 12-bit, 10-bit, or 8-

bit. It is possible to use external triggers with the camera (CC1 signal or TTL_IO trigger input) in

different trigger modes see ”Synchronization Modes” on page 6 The camera configuration and

settings are done via the Camera Link serial communication. This interface is used for:

• Gain and offset setting

• Data output format

• Synchronization modes: free-run or external trigger modes

• Shutter time

• Test pattern generation

• Upload and download of correction data (FPN column correction, LUT)

CMOS

SENSOR

Microcontroller

CameraLink

Transceiver

Power Supplies

DC power

Camera Link

I/F

Sequencer

Controller

Data

Serial Line

Trigger

Strobe, LVAL

Shutter

FVAL

Trigger

Shutter