Owner's manual

17
5440A–IMAGE–10/05
[Preliminary] ATMOS -2M60/2M30
10A 1 RW - 0
Current configuration restore from Eeprom
1 to 4: User settings
10B 1 WO -
FPN coefficient save in dataflash
1 to 4 (1 allowed only for advanced user
mode)
10C 1 RW - 1
FPN coefficient restore in dataflash
1 to 4
10D 1 WO -
LUT coefficient save in dataflash
1 to 4 (1 allowed only for advanced user
mode)
10E 1 RW - 1
LUT coefficient restore in dataflash
1 to 4
200 2 RW RW 0
Calibration control
[0] = off-line calibration enabled
(0: disabled; 1: enabled)
202 2 RW - 0
Processing control:
[0] = offset correction enable (0: disabled;
1: enabled)
[1] = gain correction enable (0: disabled;
1: enabled)
[2] = look-up table correction enable
(0: disabled; 1: enabled)[
[4:3] = fpn correction mode (00: disabled;
01: off-line fpn correction enabled; 11: on-
line fpn correction enabled)
204 2 RW - 0
Mode control:
[1:0] = test pattern (00: disabled; 01: fixed
test pattern; 10: dynamic test pattern)
[3:2] = output format (00:12-bit; 01:10-bit;
10:8-bit)
[[7:5] = synchronization mode (000: Free-
run; 001: External triggered; 010: external
triggered without full reset; 011: integration
time controlled); others reserved
[8] = trigger source (0: Camera Link; 1:
external)
[9] = trigger polarity (0:positive edge; 1:
negative edge)
[10] = shutter polarity output (0: positive
edge; 1: negative edge)
206 1 WO
Software reset:
1 = camera reset
Table 6-6. Internal Register Mapping (Continued)
Start Addr
(Hex) Size (Dec)
End
Addr (Hex)
Access Type
Processing Internal Task
Factory
Settings Description