Owner manual

41
AT76C551
1612D–08/01
• Bit 11 – RxFifoAlmFull_ IntEnable
RX FIFO almost full interrupt enable.
• Bit 10 – GenPurpTim_IntEnable
General purpose compare timer interrupt enable.
• Bit 9 – TxAcCodeComplete_IntEnable
TX of Access Code has been completed.
• Bit 8 – RxTxStart_ IntEnable
RX/TX start compare timer interrupt enable.
• Bit 7 – TxPktComplete_IntEnable
TX packet completion interrupt enable.
• Bit 6 – RxCorrelTrig_IntEnable
Correlator trigger interrupt enable.
• Bit 5 – RxHecFail_IntEnable
HEC fail interrupt enable.
• Bit 4 – RxCrcFail_IntEnable
CRC fail interrupt enable.
• Bit 3 – RxFecFail_IntEnable
FEC fail interrupt enable.
• Bit 2 – RxPktHeaderRdy_IntEnable
RX packet header arrival interrupt enable.
• Bit 1 – RxPayHeaderRdy_IntEnable
RX payload header arrival interrupt enable.
• Bit 0 – RxPayloadRdy_IntEnable
RX payload completion interrupt enable.
Note: Default Value: 00000000 hex
IntClear
addr: 60005C hex W 32 bits
• Bits 31..11 – Reserved
• Bit 10 – GenPurpTim_IntClear
Clears general purpose compare timer interrupt
• Bit 9 – TxAcCodeComplete_IntClear
Clears access Code Tx completed interrupt
• Bit 8 – RxTxStart_IntClear
Clears RX/TX start compare timer interrupt
• Bit 7 – TxPktComplete_IntClear
Clears TX packet completion interrupt
• Bit 6 – RxCorrelTrig_IntClear
Clears correlator trigger interrupt
• Bit 5 – RxHecFail_IntClear