Manual

AT75C310

• EEVTEDG: External Event Edge Selection

• EEVT: External Event Selection

Note: 1. If TIOB is chosen as the external event signal, it is configured as an input and no longer generates waveforms.

• ENETRG: External Event Trigger Enable

0 = The external event has no effect on the counter and its clock. In this case, the selected external event only controls

the TIOA output.

1 = The external event resets the counter and starts the counter clock.

• CPCTRG: RC Compare Trigger Enable

0 = RC Compare has no effect on the counter and its clock.

1 = RC Compare resets the counter and starts the counter clock.

• WAVE = 1

0 = Waveform mode is disabled (capture mode is enabled).

1 = Waveform mode is enabled.

• ACPA: RA Compare Effect on TIOA

• ACPC: RC Compare Effect on TIOA

EEVTEDG Edge

00None

0 1 Rising edge

1 0 Falling edge

1 1 Each edge

EEVT

Signal Selected as

External Event

TIOB

Direction

0 0 TIOB Input

(1)

0 1 XC0 Output

1 0 XC1 Output

1 1 XC2 Output

ACPA Effect

0 0 None

01Set

10Clear

11Toggle

ACPC Effect

00None

01Set

1 0 Clear

1 1 Toggle