User Manual

AT75C220
10
Peripheral Memory Map
The register maps for each peripheral are described in the corresponding section of this datasheet. The peripheral memory
map has 16K bytes reserved for each peripheral.
Initialization
Reset initializes the user interface registers to their default
states as defined in the peripheral sections of this
datasheet and forces the ARM7TDMI to perform the next
instruction fetch from address zero. Except for the program
counter, the ARM core registers do not have defined reset
states. When reset is active, the inputs of the AT75C220
must be held at valid logic levels.
There are three ways in which the AT75C220 can enter
reset:
1. Hardware reset. Caused by asserting the RESET
pin, e.g., at power-up.
2. Watchdog timer reset. The WD timer can be pro-
grammed so that if timed out, a pulse is generated
that forces a chip reset.
3. Software reset. There are two software resets which
are asserted by writing to bits [11:10] of the SIAP
mode register. SIAP_MD[11] forces a software reset
with RM set low and SIAP_MD[10] forces a reset
with RM set high.
Reset Pin
The reset pin should be asserted for a minimum of 10 clock
cycles. However, if external DRAM is fitted, then reset
should be applied for the time interval specified by the
SDRAM datasheet, typically 200 µs. The OakDSPCores
are only released from reset by the ARM program control.
When reset is released, the pin NDSRA/BOOTN is sam-
pled to determine if the ARM should boot from internal
ROM or from external memory connected to NCS0. The
details of this boot operation are described in the section
“Boot Mode” on page 11.
Processor Synchronization
The ARM and the OakDSPCore processors have their own
PLLs and at power-on each processor has its own indeter-
minate lock period. To guarantee proper synchronization of
inter-processor communication through the mailboxes, a
specific reset sequence should be followed.
Once the ARM core is out of reset, it should set and clear
the reset line of the OakDSPCore three times. This guaran-
tees message synchronization between the ARM and the
OakDSPCore.
Table 3. AT75C220 Peripheral Memory Map
Base Address (Normal Mode) Peripheral Description
0xFF000000 MODE AT75C220 Mode Controller
0xFF004000 SMC Static Memory Controller
0xFF008000 SDMC SDRAM Controller
0xFF00C000 PIOA Programmable I/O
0xFF010000 PIO B Keypad PIO
0xFF014000 TC Timer/Counter Channels
0xFF018000 USARTA USART
0xFF01C000 USARTB USART
0xFF020000 SPI Serial Peripheral Interface
0xFF024000 Reserved
0xFF028000 WDT Watchdog Timer
0xFF030000 AIC Interrupt Controller
0xFF034000 MACA MAC Ethernet
0xFF038000 MACB MAC Ethernet
0xFFFFF000 AIC (alias) Interrupt Controller