Owner's manual

10
AT45DB021B
1937F–DFLSH–10/02
Note: In Tables 2 and 3, an SCK mode designation of “Any” denotes any one of the four modes of operation (Inactive Clock Polarity
Low, Inactive Clock Polarity High, SPI Mode 0, or SPI Mode 3).
Table 1. Read Commands
Command SCK Mode Opcode
Continuous Array Read
Inactive Clock Polarity Low or High 68H
SPI Mode 0 or 3 E8H
Main Memory Page Read
Inactive Clock Polarity Low or High 52H
SPI Mode 0 or 3 D2H
Buffer 1 Read
Inactive Clock Polarity Low or High 54H
SPI Mode 0 or 3 D4H
Buffer 2 Read
Inactive Clock Polarity Low or High 56H
SPI Mode 0 or 3 D6H
Status Register Read
Inactive Clock Polarity Low or High 57H
SPI Mode 0 or 3 D7H
Table 2. Program and Erase Commands
Command SCK Mode Opcode
Buffer 1 Write Any 84H
Buffer 2 Write Any 87H
Buffer 1 to Main Memory Page Program with Built-in Erase Any 83H
Buffer 2 to Main Memory Page Program with Built-in Erase Any 86H
Buffer 1 to Main Memory Page Program without Built-in Erase Any 88H
Buffer 2 to Main Memory Page Program without Built-in Erase Any 89H
Page Erase Any 81H
Block Erase Any 50H
Main Memory Page Program through Buffer 1 Any 82H
Main Memory Page Program through Buffer 2 Any 85H
Table 3. Additional Commands
Command SCK Mode Opcode
Main Memory Page to Buffer 1 Transfer Any 53H
Main Memory Page to Buffer 2 Transfer Any 55H
Main Memory Page to Buffer 1 Compare Any 60H
Main Memory Page to Buffer 2 Compare Any 61H
Auto Page Rewrite through Buffer 1 Any 58H
Auto Page Rewrite through Buffer 2 Any 59H