Installation Guide

10 - Working quickly, apply solvent weld glue to each of the six internal Chamber Sockets of the remaining
Delta End Cap and then externally to the six Chamber Pipes. Quickly bring the Delta End Cap together
with the six pipes by first aligning three pipes and sockets on one side and then rolling onto the remaining
three pipes. Using some force, push the Delta End Cap down onto the Chamber Pipes ensuring the pipes
enter the socket fully and hold in position until secure (Figure 3 - Delta Diagram).
NOTE: refer to solvent weld glue manufacturers specifications and curing times.
11 - Move the Chamber Support Spacer down the Chamber Pipes to approximately the half way position
ensuring the pipes will be supported evenly.
12 - Insert Cage/Seat & Ball into the inlet (upstream) Delta End Cap, ensuring it is oriented correctly (Figure
4).
rainharvesting.com
Figure 3
Delta Diagram
Figure 4
Inserting the Cage/Seat and Ball