Installation Guide

6 - Using priming fluid, clean all internal sockets of both Delta End Caps and each external ends of the six
Chamber Pipes.
7 - Apply solvent weld glue to the Max Chamber adaptor and glue it onto the upper end of your diversion
chamber. If you aren’t using the Max Chamber adaptor you can disregard this step.
8 - Working with one Delta End Cap, apply solvent weld glue internally to a Chamber Socket and then
externally to one of the Chamber Pipes. Bring the two together ensuring the pipe is inserted fully into the
socket and hold until firm. Repeat this step for all remaining pipes until all six Chamber Pipes are glued
into one Delta End Cap.
NOTE: All sockets of the Delta End Cap are stepped internally. The inner socket is for use with 100mm
UPVC pipe and the outer socket for 4” Sch. 40 pipe. Only apply solvent weld glue to the socket relating to
the pipe in use.
9 - Slide the Chamber Support Spacer over the open end of the Chamber Pipes and position approx.
200mm (8”) from the unglued end.
Figure 1
Suggested Installation Orientations
rainharvesting.com
Figure 2
Delta In-Ground Inlet/Outlet Position