Installation Guide

WHAT'S IN THE BOX?
TOOLS/MATERIALS YOU MAY REQUIRE
HOW IT WORKS
Installation
Quickfit Diverter valve
Quickfit Diverter round rubber collector
12mm (1/2”) garden hose fitting and seal
32mm (1 1/4”) hose fitting and seal
Screws x 2
Hole saw 35mm (1 3/8”)
Tape measure
Marker pen
Drill
Utility knife
Spirit level
Liquid soap
1 - Determine and mark the position you would like to install your Diverter. Point the outlet in the direction
you intend to route the hose. If you are connecting your Diverter to a rain barrel, make sure the diverter is
mounted level to the inlet of the barrel, which will be just below the top of the rain barrel. Use a spirit level
to check the height.
2 - Using the included hole saw, drill a hole in your downpipe at the marked position. Make sure to remove
any burrs from the edge of the hole.