Radio Antenna User Manual
be verified by checking the second line of text in the SET MODEM MODE menu
as shown below. The second line of text should show the following:
For Master radio: Modem Mode is 0
For Slave radio: Modem Mode is 1
If the radios have not been pre-configured correctly for the Modem Mode,
then configure each radio using the following:
For Master radio: Enter “0” to select Point to Point Master.
For Slave radio: Enter “1” to select Point to Point Slave.
If the Modem Mode has been configured properly, then press ESC to return to the
Main Menu.