Operating instructions

12
RailKing F-3 Diesel Engine
Care of the Remote Control
Your RailKing Remote Control System should offer years of trouble-free
service. There are a few things you can do to ensure trouble-free operation:
• If your train responds inconsistently, replace old batteries with fresh ones.
Do not mix old and new batteries.
• Remove batteries before storing for extended periods.
• Do not drop the remote. It can damage the delicate electronics inside.
• Any attempt by anyone other than an authorized M.T.H. repair person to
open and repair the handheld transmitter or lock-on may result in damage and
the loss of warranty protection.
Lubrication and Greasing Instructions
The engine should be oiled and greased in order to run properly.
You should regularly oil the engine and pickup rollers to prevent them from
squeaking. Use light household oil and follow the lubrication points marked
“L” in Fig. 5. Do not over oil. Use only a drop or two on each pivot point.
The locomotive’s internal gearing was greased at the factory and should not
need additional grease until after 50 hours of operation or one year, whichever
comes first. Use a lithium based grease and follow the greasing instructions
below.
1. Remove the four Phillips screws from the chassis, as seen in Figure 6, then
lift the body away from the chassis.
Lubricate Pick-Up
Roller (L)
Lubricate Pick-Up
Roller (L)
Lubricate Axle
Bushings (L)
Figure 5. Lubrication Points on the Engine