Operator`s manual

RailKing R-17 Subway Set 11
Headlights
To replace the headlights and other
end-of-car lights in the powered unit:
1. Remove the shell as described in the
“Lubrication and Greasing” section of
this booklet.
2. Pull out the bulb shown in Figure 8
to replace the Number/Destination
Board bulb.
3. To replace the headlight bulbs,
remove the harness witht the blue 2 pin
connector shown in Figure 9.
4. To replace the top marker lights, remove the harness
with the yellow 2 pin connector shown in Figure 9.
5. To replace the marker lights below the headlight,
remove the harness with the green 2 pin connector shown
in Figure 9.
Replacement bulbs and wire ties are available directly
from the M.T.H. Parts Department (order online:
www.mth-railking.com, e-mail: [e-mail];
mail: 7020 Columbia Gateway Drive, Columbia MD
21046-1532, FAX: [phone]).
Gently Pull Bulbs
Away From Socket To Remove
Figure 8
Unplug Headlight and Marker Light Wires
From Socket To Remove
Figure 9