Operator`s manual

RailKing R-17 Subway Set 9
Auto Mode
When you have finished programming your stations in Learn the car will be in Manual
Mode. Running in Forward, stop the car at the location of the first programmed station by
pressing the Direction button. Press Bell-Horn-Horn to put the train into Auto Mode.
Press the Direction button again to begin operation in Auto Mode. Because Auto Mode
operation begins at the first stop, the next stop announced will be the second stop.
Function Learn Mode Button Code:
To Enter Learn Mode
To Stop at Each Station
To Scroll through the Station Names
To Save Station
1 Horn, 4 Bells
Direction
Bell (hold to scroll and release as soon
as you hear the desired station name)
Horn (hold for "Saved" response)
Function Auto Mode Button Code:
To Enter Auto Mode from
Manual Mode
To Begin Programmed Run
1 Bell, 2 Horn at the location of the
first programmed station stop
Direction
Function Manual Mode Button Code:
To Enter Manual Mode
from Auto Mode
1 Bell, 2 Whistles
This locomotive is equipped with one coil-wound Proto-Coupler for remote uncoupling
action. Because Proto-Couplers are controlled through the Proto-Sound 2.0
microprocessor, they do not require an uncoupling track section or modification to your
layout to function. You can fire a coupler from neutral or while in motion. Use the code
shown below (and in the chart on p. 7) to fire the coupler(s).
Front Coupler:
To fire the front coupler (if your engine has one), quickly tap the Bell button once
followed by four quick taps of the Horn button, allowing approximately ½ second to
lapse between each quick button press. The sound of the liftbar and air line depletion
will play, and the knuckle will be released.
Horn Horn
Fire
Front
Coupler
= Horn Horn
Bell
Proto-Coupler® Operation