User manual

Step 3

Select “Internet Protocol (TCP/IP)” and click “Properties”. A window for IP address settings

will pop up.

Step 4 Conﬁ gure the IP address, subnet mask, gateway and DNS. You can consult with the MIS

personnel in your company for the related IP address.

Step 5 After the conﬁ guration, click “OK” to complete the settings. (If you need to change the IP

address in the future, you should make sure that the IP address used by SR7650-4S-U3D is

in the same domain to ensure the proper system operation.)

Step 6 Login the system. The default IP address of SR7650-4S-U3D is 192.168.0.1. Open your

web browser and input:

http://192.168.0.1 or https://192.168.0.1 (using Secure Sockets Layer connection to transfer data with

encryption. Note that data transfer speed will be compromised under this connection mode)

To use the system for the ﬁ rst time, click any of the functions to pop up the screen requesting for account

and password. The default username and password are as follows:

Default Password: 1234

Click OK to login. Please refer to Chapter 3 for following detailed instructions.

4. System Setup

After the login to the system, you can use “Quick install” function for quick conﬁ guration. On RAID levels

0, 1, 3, 5 and 6, the system will automatically calculate the maximum available capacity, which is subject

to the number of your hard disks and currently available capacity.

Step 1 Select “Quick install” and then select a RAID level. Please refer to the ﬁ gure below. After

selecting a RAID level, click “ ” to enter next page to conﬁ gure “Bus ID”

/“SCSI ID”/“LUN”