User manual

Chapter 3 User Interface Introduction
3.1 User Interface Architecture
The following is the GUI architecture:
Quick Install
Æ
Step 1 / Step 2 / Step 3 / Confi rm
System Confi g
System name
Æ
System name
IP address
Æ
DHCP / Static
SCSI
Æ
SCSI bus setting
Login confi g
Æ
Auto logout / Login lock
Password
Æ
Old password / Password / Confi rm
Date
Æ
Date / Time / Time zone / Daylight saving
Mail
Æ
Mail-from address / Mail-to address / SMTP relay / Authentication / Send test mail
SNMP
Æ
SNMP trap address / Community
Event log
Æ
Mute / Clear
Volume confi g
Physical disk
Æ
Free disc / Global spares / Dedicated spares / More information
Volume group
Æ
Create / Delete / More information / Rename / Migrate
User data volume
Æ
Create / Delete / Attach LUN / Snapshot / More information / Rename / Extend / Set read/
write mode / Set priority / Resize Snapshot space / Auto Snapshot
Cache volume
Æ
Create / Delete / More information / Resize
Logical unit
Æ
Attach / Detach
Enclosure management
SAF-TE confi g
Æ
Enable / Disable
Voltage & Temperature
Æ
Auto shutdown
S.M.A.R.T.
Æ
S.M.A.R.T. for physical disks
UPS
Æ
UPS Type / Shutdown Battery Level / Shutdown Delay / Shutdown UPS
Maintenance
Upgrade
Æ
Browse the fi rmware to upgrade
Info
Æ
System information
Reset to default
Æ
Reset to factory default
Confi g import & export
Æ
Controller confi guration import and export function
Shutdown
Æ
Reboot / Shutdown
Logout
3.2 Login
STARDOM SCSI Series Products supports graphic user interface (GUI) to operate the system. Make
sure the network cable is already connected and confi gured to the same domain as your current related
devices. Please refer to 2.3.1 for related confi gures. The following descriptions are examples based on
the default IP address: 192.168.0.1. Please open your web browser and input:
http://192.168.0.1
To use the system for the fi rst time, click any of the functions to pop up the dialog window requesting for
account and password. The default account and password are as follows:
Login account: admin
Default Password: 1234
After login, you can choose a function from the list to the left side of the window for related confi gures.
There are three indicators at the top-right corner of the window. Each indicates:
1. Voltage light: Green indicates normal. Red indicates abnormal voltage status. Please refer to
section 3.6.2 for more details.
2. Temperature light: Green indicates normal. Red indicates abnormal system temperature.
3. RAID light: Green indicates RAID is working properly. Red indicates RAID error.
30 User Interface Introduction User Interface Introduction 31