User manual

Step 4 Once the installation is completed, insert the tray back and ﬁ x it ﬁ rmly in the proper place.

Step 5 Connect the cables to the corresponding jacks. Make sure that you have connected the

corresponding cables and devices to two SCSI ports, one LAN or RS-232 port and four

eSATA ports (optional). Then connect the power cord.

Step 6 Hardware installation is completed. You can power on the system to start the related setup

and application.

You can use related management interfaces to make the respective conﬁ gurations. Please refer to

Chapter 3.

2.3 Management Methods

You can manage the STARDOM SCSI Series Products by one of the following three methods. Each

method is described as follows:

2.3.1 User Management Interface (Web GUI)

STARDOM SCSI Series Products support Graphic User Interface (GUI) for system management. Before

getting started, make sure the related network port is connected. If you want to use a static IP address,

make sure the IP address is not conﬂ icting with other IP address. You can use the “ping” command to

verify if IP address conﬂ iction occurs.

The default IP address of STARDOM SCSI Series Products is 192.168.0.1. The following instructions

describe how to start your initial setup by congifuring a static IP address in Windows XP system.

Step 1 First, verify if IP address conﬂ iction occurs. Click Start→ Run→Input ping xxx.xxx.xxx.xxx (the IP

address you are going to use). If you get a reply of “Request time out.”, then you can use the

IP address. It is recommend that you may also consult with your MIS personnel directly for the

related IP address information.

Step 2 Conﬁ gure the domain. Click Start→Settings→Network Connections. A dialog window for your

current network connection will pop up. Select “Network Connections” and then click “Properties”.

Step 3 Select “Internet Protocol (TCP/IP)” and click “Properties”. A window for IP address

settings will pop up.

Installation Installation 23