User Manual
9 / 12
IMPORTANT NOTE:
Although this section can be used as a quick start guide, we
strongly suggest that you read the entire manual before proceeding. This checklist is
NOT intended to replace the content included in this instruction manual.
- Always turn the transmitter on rst.
- Ensure the throttle control stick is at bottom position before connecting the battery.
- Fly the model (hand-launch or take off from a at/level surface).
- Land the model (on a at/level surface).
- Unplug the battery from ESC.
- Always turn off the transmitter last.
Flight Checklist
Binding is the process of programming the receiver to recognize the
GUID (Globally Unique Identier) code of a single specic transmitter. When a receiver
is bound to a transmitter, the receiver will only respond to that specic transmitter.
Binding Instructions
If you need to rebind for any reason, please follow the steps below.
1. Keep the transmitter switched OFF with the throttle stick at bottom position.
NOTICE:
Keep PASS switch at Partial or Full assist position.
NOTICE:
Make sure you keep the plane still in a calm, stable position when initializing
the PASS system.
2. Connect the battery to the plane, then turn on the transmitter within 5 seconds.
3.The receiver LED will ash for 3 to 8 seconds before binding automatically.
4. After the receiver LED stops ashing, the binding process is complete and you are
ready to y.
CAUTION:
Remember to use caution when ying near people and property!