User's Manual

This module is not a limited module
2.5 Antenna designs
MDL NRF24L01+ 02 shall be manufactured with a straight, solid core, 24AWG wire 30+/‐1mm
long, and soldered into the wire pad labeled “ANT1” on the Board. PCB layout specifications are
as follows:
A deviation(s) from the defined parameters of the antenna of either module, as described by
the instructions, require that the host product manufacturer must notify the module grantee
that they wish to change the antenna design. In this case, a Class II permissive change
application is required to be filed by the grantee, or the host manufacturer can take
responsibility through the c hange in FCC ID (new application) procedure followed by a Class II
permissive change application.
2.6 RF exposure considerations
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment, for a minimum separation of 5mm between antenna and body. The host product
manufacturer will provide the above information to end users in their end‐product manuals.
2.7 Antennas
Quarter wave monopole antenna; 5.19dBi; 2.4046‐2.4796GHz
2.8 Label and compliance information
The end product must carry a physical label, following KDB784748D01 and KDB 784748 stating
“Contains Transmitter Module FCC ID:YZHMDLNRF24L0102”.