User's Manual

Please notice that if the ISED certification number is not visible when the module is installed
inside another device, then the outside of the device into which the module is installed o display
a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains IC: 9314A‐MDLNRF24L01” any similar wording that expresses the same
meaning may be used.
l'appareil hôte doit porter une étiquette donnant le numéro de certification du module
d'Industrie Canada, précédé des mots «Contient un module d'émission », du mot « IC: 9314A‐
MDLNRF24L01 » ou d'une formulation similaire exprimant le même sens, comme suit
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and
compliance with RSS‐102 RF exposure, users can obtain Canadian information on RF exposure
and compliance.
Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS
102 etla conformité
à l'exposition de RSS‐102 rf, utilisateurs peut obtenir l'information canadienne surl'exposition et
la conformité de rf.
This transmitter must not be co‐located or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
Cet émetteur ne doit pas être Co‐placé ou ne fonctionnant en même temps qu'aucune autre
antenne ouémetteur. Cet équipement devrait être installé et actionné avec une distance
minimum de 20 centimètres entre le radiateur et votre corps.
FCC Compliance Information
Integrator is reminded to assure that these installation instructions will not be made available to the
end‐user of the final host device.
The final host device, into which this RF Module is integrated, must be la belled with an auxiliary label
stating the FCC ID of the RF Module, such as:
“Contains FCC ID: YZH MDLNRF24L0102
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device not cause harmful interference and
(2) This device must accept an interference received, including interference that may cause
undesired operation.”
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant of Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction, may cause harmful