User's Guide

2.6 RF exposure considerations
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment, for a minimum separation of 5mm between antenna and body. The host product
manufacturer will provide the above information to end users in their end-product manuals.
2.7 Antennas
PCB antenna; 1.6dBi; 2.401-2.480GHz
2.8 Label and compliance information
The end product must carry a physical label, following KDB784748D01 and KDB 784748 stating
“Contains Transmitter Module FCC ID: YZHMDLNRF24L0101”.
2.9 Information on test modes and additional testing requirements
To test the module as a standalone unmodulated constant carrier, refer to Appendix C in
“nRF24L01+ Product Specification.pdf” which is supplied along with this document
As noted in Appendix C, the nRF24L01+ IC requires communication via the SPI lines on the IC.
These are routed to the module connection pins.
The pin definitions are as follows:
Pin
Name
SPI Function
Specifications
W1
Vdd
Power supply for IC
Supply must be 1.9-3.6V DC
W2
GND
GND
W3
CE
N/A
Chip Enable, not used for SPI
communication
W4
CSN
Slave Select, Active Low
Pull low to enable
communication with this
device
W5
SCK
SPI Clock
W6
MOSI
Master Out Slave In for SPI
communication
MDL nRF24L01+ 01 is the
slave device
W7
MISO
Master In Slave Out for SPI
communication
MDL nRF24L01+ 01 is the
slave device
W8
IRQ
N/A
Interrupt