User's Guide

transmitter or on the device in which it is installed. If the module is installed inside
another device, then the outside of the device into which the module is installed must
display a label referring to the enclosed module. This exterior label can use wording
such as the following: “Contains FCC certified transmitter module(s).” Any similar
wording that expresses the same meaning may be used. The user manual must include
instructions on how to access the electronic display. A copy of these instructions must
be included in the application for equipment authorization.
(vii) The modular transmitter must comply with any specific rules or operating
requirements that ordinarily apply to a complete transmitter and the manufacturer must
provide adequate instructions along with the module to explain any such requirements. A
copy of these instructions must be included in the application for equipment authorization.
(viii) The modular transmitter must comply with any applicable RF exposure requirements
in its final configuration.
Allowable Antennas to Use with the SiP Module
The MIFA antenna made of PCB traces is the only allowable antenna for this SiP Module. There
are no additional connectors on the PCB for use with other antennas.
Required Labeling on the Module
FCC End Product Labeling
IC End Product Labeling
Required Labeling on the Module
FCC/IC Labeling on the Module
Required Regulatory Wording for User Guide
FCC Compliance Information
Integrator is reminded to assure that these installation instructions will not be made available to
the end-user of the final host device.
The final host device, into which this RF Module is integrated, must be labelled with an auxiliary label
stating the FCC ID of the RF Module, such as:
“Contains FCC ID:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device not cause harmful interference and
(2) This device must accept an interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant of Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against