User's Guide

MDL NRF 24L01+ 01 Module Instructions
Table of Contents
Introduction .................................................................................................................................................. 1
List of Applicable FCC Rules .......................................................................................................................... 1
Allowable Antennas to Use with the SiP Module ......................................................................................... 3
Required Labeling on the Module ................................................................................................................ 3
FCC End Product Labeling ......................................................................................................................... 3
IC End Product Labeling ............................................................................................................................ 3
Required Labeling on the Module ................................................................................................................ 3
FCC/IC Labeling on the Module ................................................................................................................ 3
Required Regulatory Wording for User Guide .............................................................................................. 3
FCC Compliance Information .................................................................................................................... 3
Module Statement .................................................................................................................................... 4
Module Integration Instructions ................................................................................................................... 4
Document History ......................................................................................................................................... 7
Introduction
The MDL NRF24L01+ 01 Transceiver Module (the module) is a System in Package (SiP) module
used to transmit and receive in the 2.4GHz band.
The module has Nordic Semiconductor nRF24L01+ Single Chip 2.4GHz Transceiver on-board to
perform RF send and receive functions on the front end with a SPI interface and input/output
buffers to communicate with a microprocessor.
List of Applicable FCC Rules
This module must comply with all guidelines specified for Single Modular Transmitters as
defined by FCC 47 CFR § 15.212(a) (1):
(a) Single modular transmitters consist of a completely self-contained radiofrequency
transmitter device that is typically incorporated into another product, host or device. Split
modular transmitters consist of two components: a radio front end with antenna (or radio
devices) and a transmitter control element (or specific hardware on which the software that
controls the radio operation resides). All single or split modular transmitters are approved with
an antenna. All of the following requirements apply, except as provided in paragraph (b) of this
section.